Innotec Double-Sided Moulding Tape 15mm x 10Mt Roll
Moulding Tape is a double-sided adhesive tape made from rubber. The special layer of glue on the tape is pressure sensitive. The advantage with this is that the part to be glued can be repositioned easily time and again
Technical Information
- Commodity Code 39199080
Data Sheets
Download the Innotec Double-Sided Moulding Tape technical data sheet (TDS) and the Innotec Double-Sided Moulding Tape safety data sheet (SDS) from Silmid today. Once you have logged in or signed up, the datasheet will be visible for download if one is available. Please login to access datasheetsProduct Properties
Product Information
The advantage with this is that the part to be glued can be repositioned easily time and again, without sticking too securely. When positioned in the right place the final adhesion can be obtained by pressing firmly.
Moulding Tape is resistant to temperatures of -40°C to +95°C. As a result of this and its perfect adhesion Moulding Tape is very good at absorbing the difference in expansion coefficient between the different materials. The dense cell structure means that the tape absorbs almost no moisture and is resistant to diesel and light chemicals.
Properties:
- Easy to apply and process.
- Can be corrected within a short time (± 5 minutes).
- Resistant to temperatures of -40°C to +95°C.
- High tensile strength.
- Resistant against: water, weak caustic se.
Surface preparation
The surface must be clean, dry and free of grease. Clean surfaces with Innotec Multisol orInnotec Seal and Bond Remover.
Application method
Apply straight from the roll and press firmly. Remove protective film and join both parts carefully. Parts can be repositioned within 5 minutes. When the parts are correctly aligned press firmly (for example with the InnoQuip Blade for Striping) to activate the pressure sensitive glue layer. Maximum adhesion after 24 hours.
Shipping information
Please refer to our delivery page for more information.