Sandstrom 9A Solid Film Lubricant

Sandstrom 9A should be applied where maximum wear life and corrosion protection from a dry film lubricant are required. Sandstrom 9A may be applied by brush, dip or spray method to a wide variety of surfaces. After it is heat cured, 9A is virtually unaffected by atmospheric and fretting corrosion, solvents, acids, oils or degreasers and is not re-softened at elevated temperatures.

Features

• Excellent Corrosion Protection
• Chemical Resistance
• Long Wear Life
• 9A CONTAINS NO GRAPHITE

Typical uses

Sandstrom 9A is an excellent solution to the problem of lubricating parts:

• That will be operated in corrosive atmospheres.
• That may be stored for long periods.
• That are seldom lubricated once they leave the factory and permanent lubrication is desired.
• Where operating pressures exceed the load-bearing capacities of ordinary oils and greases.
• Where ""clean operation"" is desired (does not collect dirt and debris like grease and oils).
• Where a protective coating and sacrificial break-in lubricant is needed.
• Where fretting and galling is a problem (e.g., splines, universal joints, keyed bearings).
• Where easy release is desired (e.g., fasteners, PVC molds).
• Where parts may be subjected to frequent disassembly.

Limitations

Do not use 9A where there is potential for contact with liquid oxygen or food.